Description: AD sampling frequency for the 10K, the sequence generator SEQ1 and SEQ2 cascade into a 16-channel sequencer, sampling mode with sequential sampling. The use of general-purpose timer T1 cycle to start AD conversion interrupt event. ADCINA0, and ADCINB0 as the reference level, the actual voltage values of 0.420 and 1.653, respectively, due to the specific characteristics of each board is slightly different, with a multimeter self-measurement of the reference voltage value. This routine ADCINA0, ADCINA1, ADCINB0, ADCINB1 four channel continuous sampling of 10 times, and then sort the sampled values of the respective channels 10, filtering, and finally take the average. Then to calculated to obtain the CalGain and CalOffset by ADCINA0, and ADCINB0 channel value, the final by these two quantities to to correction ADCINA1 and ADCINB1.
To Search:
File list (Check if you may need any files):
ADsample
........\AD03.paf
........\ADsample.c
........\ADsample.CS_
........\............\FILE.CDX
........\............\FILE.DBF
........\............\FILE.FPT
........\............\SYMBOL.CDX
........\............\SYMBOL.DBF
........\............\SYMBOL.FPT
........\ADsample.paf
........\ADsample.pjt
........\ADsample.sbl
........\cc_build_Debug.log
........\Debug
........\Debug.lkf
........\Debug.lkv
........\.....\AD03.map
........\.....\AD03.obj
........\.....\AD03.out
........\.....\ADsample.obj
........\.....\DSP28_Adc.obj
........\.....\DSP28_DefaultIsr.obj
........\.....\DSP28_Ev.obj
........\.....\DSP28_GlobalVariableDefs.obj
........\.....\DSP28_InitPeripherals.obj
........\.....\DSP28_PieCtrl.obj
........\.....\DSP28_PieVect.obj
........\.....\DSP28_SysCtrl.obj
........\DSP28_Adc.c
........\DSP28_Adc.h
........\DSP28_CpuTimers.h
........\DSP28_DefaultIsr.c
........\DSP28_DefaultIsr.h
........\DSP28_DevEmu.h
........\DSP28_Device.h
........\DSP28_ECan.h
........\DSP28_Ev.c
........\DSP28_Ev.h
........\DSP28_GlobalPrototypes.h
........\DSP28_GlobalVariable.h
........\DSP28_GlobalVariableDefs.c
........\DSP28_Gpio.h
........\DSP28_InitPeripherals.c
........\DSP28_Mcbsp.h
........\DSP28_PieCtrl.c
........\DSP28_PieCtrl.h
........\DSP28_PieVect.c
........\DSP28_PieVect.h
........\DSP28_Sci.h
........\DSP28_Spi.h
........\DSP28_SysCtrl.c
........\DSP28_SysCtrl.h
........\DSP28_Xintf.h
........\DSP28_XIntrupt.h
........\SRAM.cmd
Download