Description: This leon3 design is tailored to the Altera NiosII Startix2
Development board, with 16-bit DDR SDRAM and 2 Mbyte of SSRAM.
As of this time, the DDR interface only works up to 120 MHz.
At 130, DDR data can be read but not written.
NOTE: the test bench cannot be simulated with DDR enabled
because the Altera pads do not have the correct delay models.
* How to program the flash prom with a FPGA programming file
1. Create a hex file of the programming file with Quartus.
2. Convert it to srecord and adjust the load address:
objcopy --adjust-vma=0x800000 output_file.hexout -O srec fpga.srec
3. Program the flash memory using grmon:
flash erase 0x800000 0xb00000
flash load fpga.srec Platform: |
Size: 114780 |
Author:king.xia |
Hits:
Description: 一个航天航空用的Sparc处理器（配美国欧洲宇航局用的R_tems嵌入式操作系统）的VHDL源代码，但不能保证版图设计ASIC成功
-the Sparc processor (fitted with the United States of the European Space Agency R_tems Embedded operating system) VHDL source code, but it can not guarantee success ASIC Layout Platform: |
Size: 1873920 |
Author:韩红 |
Hits:
Description: This leon3 design is tailored to the Altera NiosII Startix2
Development board, with 16-bit DDR SDRAM and 2 Mbyte of SSRAM.
As of this time, the DDR interface only works up to 120 MHz.
At 130, DDR data can be read but not written.
NOTE: the test bench cannot be simulated with DDR enabled
because the Altera pads do not have the correct delay models.
* How to program the flash prom with a FPGA programming file
1. Create a hex file of the programming file with Quartus.
2. Convert it to srecord and adjust the load address:
objcopy --adjust-vma=0x800000 output_file.hexout -O srec fpga.srec
3. Program the flash memory using grmon:
flash erase 0x800000 0xb00000
flash load fpga.srec-This leon3 design is tailored to the Altera NiosII Startix2
Development board, with 16-bit DDR SDRAM and 2 Mbyte of SSRAM.
As of this time, the DDR interface only works up to 120 MHz.
At 130, DDR data can be read but not written.
NOTE: the test bench cannot be simulated with DDR enabled
because the Altera pads do not have the correct delay models.
* How to program the flash prom with a FPGA programming file
1. Create a hex file of the programming file with Quartus.
2. Convert it to srecord and adjust the load address:
objcopy--adjust-vma=0x800000 output_file.hexout-O srec fpga.srec
3. Program the flash memory using grmon:
flash erase 0x800000 0xb00000
flash load fpga.srec Platform: |
Size: 114688 |
Author: |
Hits:
Search - leon3 test bench