Search - traffic signal control

Search - traffic signal control - List

[Other resource] 200505060050419 DL : 0: 十字路口交通灯管理现对交通信号灯进行管理，车行道的黄灯闪烁5秒钟后，转为人行横道行人放行1分钟，然后再转为车行道车辆放行3分钟。如此循环重复。用发光二极管模拟信号灯，8255A实现对信号灯的控制（所用端口自定），8253的计数器2定时向实验系统主片8259A的IRQ7请求中断，以实现3分钟，5秒钟和1分钟的定时。实验系统8253计数器2的CLK2可接OPCLK，频率为1.19318MHZ，GATE2已接＋5V，定时可采用软硬件结合相结合的方式实现。-traffic lights at a crossroads right now management for traffic signal management, the driveway flashing yellow light five seconds later, the pedestrian crossings to release a minute and then released into driveway vehicles for three minutes. So the cycle to repeat. Using light-emitting diode signal simulation, 8255A right signals control (used to set the port), the 8253 regular counter to the two experimental system of the main unit there 8259A interrupt request, to achieve 3 minutes, 5 seconds and one minute timing. Experimental System to the 8253 counter two OPCLK CLK2 access, frequency of 1.19318MHZ, GATE2 has received +5 V, which combines hardware and software regularly use a combination of ways.
Date : 2008-10-13 Size : 42.26kb User : hzl
[Other resource] codeofvhdl2006 DL : 1: 【经典设计】VHDL源代码下载～～其中经典的设计有：【自动售货机】、【电子钟】、【红绿灯交通信号系统】、【步进电机定位控制系统】、【直流电机速度控制系统】、【计算器】、【点阵列LED显示控制系统】基本数字逻辑设计有：【锁存器】、【多路选择器】、【三态门】、【双向输入|输出端口】、【内部（缓冲）信号】、【编码转换】、【加法器】、【编码器/译码器】、【4位乘法器】、【只读存储器】、【RSFF触发器】、【DFF触发器】、【JKFF触发器】、【计数器】、【分频器】、【寄存器】、【状态机】 - [ Classics design ] the VHDL source code downloads ~ ~ classics the design to include: [ Vending machine ], [ electron clock ], [ traffic light traffic signal system ], [ step of 杩涚數 machine localization control system ], [ direct current machine speed control system ], [ calculator ], [ array LED display control system ] the basic numeral logical design includes: [ Latch ], [ multichannel selector ], [ 涓夋
Date : 2008-10-13 Size : 43.15kb User : senkong
[Other resource] Led_Light DL : 0: 交通信号控制keil源码-traffic signal control Keil FOSS
Date : 2008-10-13 Size : 7.6kb User : 沈凡
[Other resource] CROSS DL : 0: 自动交通管理系统用红、绿、黄三支共两组发光二极管表示交通信号灯，利用单片机模拟有时间显示的定时交通信号灯控制管理。信号灯的变化规律可如下： 1）放行线：绿灯亮放行25秒，黄灯亮警告5秒，然后红灯亮禁止。 2）禁止线：红灯亮禁止30秒，然后绿灯亮放行。 3）当某一方向的红灯亮时，若该方向有车通过，则用扬声器声报警。（撞红灯信号可用3-5V模拟量表示）同时用2位数码管进行30秒钟递减时间显示。-automatic traffic management system using red, green, yellow a total of three light-emitting diodes, said two traffic lights, using SCM time simulation shows the regular traffic signal control. Signal changes in the law to be as follows : 1) Release Line : green clearance 25 seconds, bright yellow warning five seconds, and then the red-ban. 2) prohibit the lines : red-Ban 30 seconds, then green clearance. 3) When the red light in one direction - that if the direction of a car passed, the use of loudspeakers sound alarm. (Red light signals can hit 3 - 5V analog said), while using two digital tube for 30 seconds decreasing time displayed.
Date : 2008-10-13 Size : 2.1kb User : gjb
[Other resource] 急救车与交通灯 DL : 1: 急救车与交通灯）（1）南北与东西方向，每个方面由红黄绿三个灯控制（2）南北向：　红（30秒），黄（5秒），绿（25秒）　　　东西向：红（35秒），黄（5秒），绿（25秒）　　　上述基本参数可以根据实际情况自行调整，灯的变化规律与实际路口规律相同，绿灯在最后5秒钟时，黄灯亮，然后红灯亮，不允许两个方面同时亮绿灯。（3）绿灯的时间显示在数码管上进行显示。（4）可以通过一个开关控制，当开关信号为0时，整个交通灯全灭提高要求：（1）设计一个紧急控制开关信号，当紧急开关信号为1时，两个方向的灯全为红灯。紧急开关撤消后，按照开关按下之前的状态继续运行（其参数要保存）。（2）设计一个夜间行车开关，当开关按下后，两个方向都只有黄灯闪烁，其它灯熄灭。（3）设计两个方向的亮时时间可调。-emergency vehicles and traffic lights) (1) North and South and east-west direction, each with three yellow-green from red lights control (2) to the north and south : red (30 seconds), yellow (5 seconds), Green (25 seconds) to things : red (35 seconds), yellow (5 seconds) Green (25 seconds) above basic parameters can be adjusted to the actual situation, the light changes with the actual law of the same intersection, the green light in the final five seconds, the yellow light is on, and then a red light, bright, not two fronts simultaneously bright green. (3) the green light at the time displayed on the digital display control. (4) can be controlled by a switch, when the switch signal to 0, the whole prospect of traffic lights to improve requirements : (1) Design an emergency control switch
Date : 2008-10-13 Size : 1.57kb User : dd