Search - traffic Signal and System

Search - traffic Signal and System - List

[Other resource] 200505060050419 DL : 0: 十字路口交通灯管理现对交通信号灯进行管理，车行道的黄灯闪烁5秒钟后，转为人行横道行人放行1分钟，然后再转为车行道车辆放行3分钟。如此循环重复。用发光二极管模拟信号灯，8255A实现对信号灯的控制（所用端口自定），8253的计数器2定时向实验系统主片8259A的IRQ7请求中断，以实现3分钟，5秒钟和1分钟的定时。实验系统8253计数器2的CLK2可接OPCLK，频率为1.19318MHZ，GATE2已接＋5V，定时可采用软硬件结合相结合的方式实现。-traffic lights at a crossroads right now management for traffic signal management, the driveway flashing yellow light five seconds later, the pedestrian crossings to release a minute and then released into driveway vehicles for three minutes. So the cycle to repeat. Using light-emitting diode signal simulation, 8255A right signals control (used to set the port), the 8253 regular counter to the two experimental system of the main unit there 8259A interrupt request, to achieve 3 minutes, 5 seconds and one minute timing. Experimental System to the 8253 counter two OPCLK CLK2 access, frequency of 1.19318MHZ, GATE2 has received +5 V, which combines hardware and software regularly use a combination of ways.
Date : 2008-10-13 Size : 42.26kb User : hzl
[Other resource] CROSS DL : 0: 自动交通管理系统用红、绿、黄三支共两组发光二极管表示交通信号灯，利用单片机模拟有时间显示的定时交通信号灯控制管理。信号灯的变化规律可如下： 1）放行线：绿灯亮放行25秒，黄灯亮警告5秒，然后红灯亮禁止。 2）禁止线：红灯亮禁止30秒，然后绿灯亮放行。 3）当某一方向的红灯亮时，若该方向有车通过，则用扬声器声报警。（撞红灯信号可用3-5V模拟量表示）同时用2位数码管进行30秒钟递减时间显示。-automatic traffic management system using red, green, yellow a total of three light-emitting diodes, said two traffic lights, using SCM time simulation shows the regular traffic signal control. Signal changes in the law to be as follows : 1) Release Line : green clearance 25 seconds, bright yellow warning five seconds, and then the red-ban. 2) prohibit the lines : red-Ban 30 seconds, then green clearance. 3) When the red light in one direction - that if the direction of a car passed, the use of loudspeakers sound alarm. (Red light signals can hit 3 - 5V analog said), while using two digital tube for 30 seconds decreasing time displayed.
Date : 2008-10-13 Size : 2.1kb User : gjb