Search - light off

Search - light off - List

[Other Embeded program] main DL : 0: 采用新一代超强抗干扰/强抗静电/高速/低功耗单片STC11F32XE为数据处理和控制的路灯照明智能系统。该单片机实现了对路灯的亮灭控制、报警、还有定时功能。通过A/D转换TLV2543检测LED故障，D/A转换芯片TLC5620控制LED灯状态，利用光敏电阻原理和红外对管特性实现自动调节路灯开关状态。同时成功设计了恒流驱动电源电路，使LED正常稳定的工作，并完成了自动调节路灯驱动电源输出功率，基本上解决了LED灯不能工作在稳定电流的问题。-Interference by a new generation of super/strong antistatic/high speed/low power single STC11F32XE for data processing and control of street lighting intelligent systems. The MCU of the bright lights off control, alarm, there is timing. Through the A/D conversion TLV2543 LED fault detection, D/A converter chip TLC5620 control LED light status, use of resistance theory and the infrared photosensitive properties of the tube lamp switch automatically adjust the state. Also successfully designed constant current drive power supply circuit, so that the normal steady LED 的 exercise and complete the Zidong adjust lamp drive power Shuchu power basically solved LED 灯 not work in the stable current problems.
Date : 2025-12-29 Size : 8kb User : mengying
[Other Embeded program] 9.Joystick DL : 0: zigbee cc2430模块，用按钮控制开发板上四个led的亮灭-zigbee cc2430 module, development board with a button to control the light off of four led
Date : 2025-12-29 Size : 55kb User : 莫为
[Other Embeded program] flashlight DL : 0: 在P1.0端口上接一个发光二极管L1，使L1在不停地一亮一灭，一亮一灭的时间间隔为0.2秒-In the P1.0 port after another light-emitting diode L1, L1 is constantly making a bright off, a bright off the time interval 0.2 seconds
Date : 2025-12-29 Size : 32kb User : 遥望
[Other Embeded program] PWM DL : 0: 利用定时器产生LED灯由亮到灭，由灭到亮逐步变化。-Generated by the timer LED lights from bright to off, the light gradually changes from the off.
Date : 2025-12-29 Size : 4kb User : 菜头
[Other Embeded program] 33666 DL : 0: 8个发光管由上至下间隔1s流动其中每个管亮500ms,灭500ms,亮时蜂鸣器响灭时关闭蜂鸣器，一直重复下去。-8 LED top-down flow of the interval in which each tube light 1s 500ms, OFF 500ms, lit off the buzzer when the buzzer off, has been repeated down.
Date : 2025-12-29 Size : 1kb User : 刘艺
[Other Embeded program] keil22 DL : 0: 通信工程大三单片机实验程序控制LED有规律亮灭-Communication Engineering junior SCM experiment a regular program control LED light off
Date : 2025-12-29 Size : 31kb User : lidong
[Other Embeded program] KeyBoard DL : 0: STM32F103ZET6 矩阵键盘控制LED灯，1-8按键点亮LED1-8,9-16按键关闭LED1-8-STM32F103ZET6 matrix keyboard control LED light 1-8-key light LED1-8 ,9-16 button to turn off LED1-8
Date : 2025-12-29 Size : 473kb User : Derek Li
[Other Embeded program] honglvdeng DL : 0: PLC红绿灯系统，自带故障检测，四方向同时进行。故障自动断电，人工复位-PLC traffic light system , its own fault detection Four directions at the same time . Fault auto power off, manual reset
Date : 2025-12-29 Size : 3kb User : SnailJay
[Other Embeded program] Key DL : 0: 本文件有三个外部中断函数实现了一个功能，即切换LCD的背光亮灭。当按下任意一个按键时，背光状态改变。本文件的串口输入中断函数实现了一个功能，即回显输入字符。-This document has three external interrupt function implements a function, that is, switching the LCD back light off. When any button is pressed, the backlight state changes. This document serial input interrupt function implements a function that echo the input character.
Date : 2025-12-29 Size : 502kb User : 孙雪平
[Other Embeded program] liushuideng DL : 0: 利用单片机控制发光二极管，使发光二极管依次亮灭，形成流水灯-Microcontroller to control the light-emitting diodes, light-emitting diodes in turn off bright, the formation of water lights
Date : 2025-12-29 Size : 15kb User : 韦义宏
[Other Embeded program] LED DL : 0: This program makes light emitting diode on and off based on switch pressed
Date : 2025-12-29 Size : 57kb User : palasaniya
[Other Embeded program] Coded-lock DL : 0: 程序功能：本程序结合了24C02存储器的存储功能，可以掉电保存密码。第一次运行时，若输入000000原始密码后无反应，可以试验着将主程序中前面的一小段被注释线屏蔽的程序前的注释线删掉，然后重新编译下载（可以将密码还原为000000）。此后，再将这小段程序屏蔽掉，再编译下载。方可正常使用。1、开锁：下载程序后，直接按六次S7（即代表数字1），8位LED亮，锁被打开，输入密码时，六位数码管依次显示小横杠。2、更改密码：只有当开锁（LED亮）后，该功能方可使用。首先按下更改密码键S16，然后设置相应密码，此时六位数码管会显示设置密码对应的数字。最后设置完六位后，按下S17确认密码更改，此后新密码即生效。3、重试密码：当输入密码时，密码输错后按下键S18，可重新输入六位密码。当设置密码时，设置中途想更改密码，也可按下此键重新设置4、关闭密码锁按下S19即可将打开的密码锁关闭。-Program function: this program combines 24 c02 memory storage function, can power-fail save the password. The first operation, if the input 000000 original password no reaction, can test the main program in the front of the a small section of the comment line screening program before the comment line out, then to recompile the download (can be password reduction for 000000). Since then, then this small segment of a program, shielding off, recompilation download. Can be normal use. 1, unlocking: download procedures, directly according to six times S7 (namely represent Numbers 1), eight LED light, lock is opened, password, six digital tube display in small shaft. 2, to change password: only when the lock (LED light), this function can be used. First press to change password key S16, then set the corresponding code, the six digital tube will display set password corresponding digital. The last set the six, press S17 confirm password change, then the new password is effective. 3, retry pas
Date : 2025-12-29 Size : 34kb User : zhanghuasheng
[Other Embeded program] MINISTM32-uCOSII-DS0-DS1 DL : 0: ALIENTEK MINISTM32 扩展实验8 uCOSII控制DS0 DS1亮灭-ALIENTEK MINISTM32 extended the the experimental 8 uCOSII control light off DS0 DS1
Date : 2025-12-29 Size : 132kb User : peter
[Other Embeded program] C51_UART DL : 0: 将实验箱232通信的接收端与发送端短接，P1.0接一个发光二极管，编写串口自发自收（查询方式）通信程序，检查本单片机的串口是否完好，如果发送字符与接收字符一致，则P1.0亮一秒灭一秒闪亮；否则，P1.0熄灭。设fosc=11.0592MHz，波特率为9600。要求用定时器T0实现1S的延时。 -Shorted to the experimental box 232 receiving end of the communication with the sender, P1.0 by a light-emitting diode, preparation of serial spontaneous self-closing (query mode) communication program, check the serial port of the microcontroller is intact, if you send and receive characters consistent P1.0 bright one second off one second shiny Otherwise, P1.0 extinguished. Let fosc = 11.0592MHz, a baud rate of 9600. The 1S delay requirements timer T0.
Date : 2025-12-29 Size : 76kb User : 邓小梨
[Other Embeded program] asfart DL : 0: 函数法的流水灯有别于数组法流水灯实现8位灯的亮灭-Function method of light water is different from the array method light water eight lights light off
Date : 2025-12-29 Size : 1kb User : xinyuan
[Other Embeded program] watchdog DL : 0: 定时模式：将WDT设置为定时模式产生定时中断，控制P1.0的输出，使LED周期亮灭。看门狗模式：将WDT设置成看门狗模式，此时，当看门狗定时器溢出时，将会产生复位。 -Timing mode: WDT setting the timing mode timer interrupt, control the P1.0 output, the LED cycle light off. Watchdog mode: WDT set watchdog mode, at this time, when the watchdog timer overflows, it will generate a reset.
Date : 2025-12-29 Size : 58kb User : 王丹妮
[Other Embeded program] stm32 DL : 0: stm32外部中断,进入中断后点亮小灯，让小灯实现亮灭-stm32 external interrupts, after entering the interrupt lit a small lamp, so that small lights to achieve light off
Date : 2025-12-29 Size : 3.99mb User : 张锋
[Other Embeded program] ex1 DL : 0: PC104总线，使接在PB口上的4个绿灯亮，4个红灯灭-PC104 bus, so connected to the PB port 4 green light, red light off 4
Date : 2025-12-29 Size : 1kb User : 陈珠英
[Other Embeded program] Lock DL : 0: 用STC单片机，实现4个数字4位密码锁的功能，并显示在数码管上。具体如下K1,K2,K3,K4,键分别代表数字1，2，3，4，K5为确认键，如果输入用户存放的正确密码，则单片机上的LED实行循环亮灭功能，如输错了3次,LED等则全亮。- Use of STC to achieve four digits 4 lock function, and displayed on a digital pipe. Follows K1, K2, K3, K4, representing key figures 1,2,3,4, K5 is OK button, if you enter the correct password for the user is stored, the LED on the implementation of SCM light off circulation features, such as mistyped 3, LED, etc. are all bright.
Date : 2025-12-29 Size : 40kb User :
[Other Embeded program] io DL : 0: 过单片机的I/O口控制LED的亮灭，从而观察I/O口的输出。实验2通过单片机的I/O口接受按键动作信息，然后通过LED和数码管指示-Through the microcontroller I/O port control LED light off, thereby observing the output I/O port. Experiment 2 through the microcontroller I/O port to accept keystrokes information and instructions by LED and digital control
Date : 2025-12-29 Size : 1kb User : lb

« 12 »