Search - PIPE - CodeBus

Search - PIPE - List

[Other Embeded program] sw_hex DL : 0: 在开发板上实现按键控制数码管实验，使数码管实现增一减一功能源代码-board realized in the development of the digital control of key experiments, a digital achievement of a pipe by a functional source code
Date : 2025-12-24 Size : 43kb User : 孙彤
[Other Embeded program] shuziwenduji DL : 0: 数字温度传感器DS18b20试验,用连接线将JH端子的DS12B80位与CN7或CN8的P37口相连运行此程序,温度值将在数码管上显示.用手触摸T1芯片(DS18B20)观察温度变化.-Digital temperature sensor DS18b20 test, with connecting cable terminals DS12B80 JH bit and CN7 CN8 of the P37 port or connected to run this program, the temperature value will be displayed in the digital pipe. Hand-to-T1 chip (DS18B20) observed temperature changes.
Date : 2025-12-24 Size : 3kb User : 遥望
[Other Embeded program] ADC12 DL : 0: 对P6.0脚进行单通道多次采样并将结果输出到数码管出-The channel number on the P6.0 pin and the output to a digital sampling pipe
Date : 2025-12-24 Size : 51kb User : 朱晓力
[Other Embeded program] IIC-EEPROM DL : 0: 本文件是I2C总线读写EEPROM(AT24C02)测试程序；将跳线器JP6的1，2脚短接，JP10的1，2脚短接，当按下KEY1，KEY2，KEY3任一键时会将对应的键值“1”，“2”，“3”写入EEPROM，同时数码管有提示，程序只保存最后一个键值，当按下KEY4时，程序会读出保存的最后一个键值，同时显示在数码管上。-This document is the I2C bus to read and write EEPROM (AT24C02) test procedures the 1,2-foot jumper shorted JP6, JP10 shorted 1,2 feet, when the press KEY1, KEY2, KEY3 any key will correspond to key " 1" , " 2" , " 3" into the EEPROM, while digital has prompted, the program saves only the last key, when pressed KEY4, the program will read the last saved key, also showed the digital pipe.
Date : 2025-12-24 Size : 33kb User : cisca
[Other Embeded program] The-speed-table DL : 0: 用单片机设计的测速表源程序。测量转速，使用霍尔传感器，被测轴安装有12只磁钢，即转轴每转一周，产生12个脉冲，要求将转速值（转/分）显示在数码管上。-The speed table with a single-chip design source. Measurement speed, the use of Hall sensors, the measured shaft with 12 magnets, one revolution of the shaft each produce 12 pulses, requires speed (r/min) displayed on the digital pipe.
Date : 2025-12-24 Size : 2kb User : 陈敏
[Other Embeded program] The-steering-gear-test-procedure DL : 0: 开机时舵机角度自动转为0度，通过实验板上的独立按键调节舵机的角度转动,并且在实验板上数码管上显示出相应的角度，本实验仅演示5个角度的控制,若想实验任意角度控制请大家自行编程实验。-Boot Angle automatic steering gear to 0 degrees, through the experiment of independent board the Angle of steering gear buttons adjust rotation, and the board digital pipe showed on the corresponding point of view, this experiment demonstration five Angle only control, if want to experiment arbitrary Angle control please to programming experiment.
Date : 2025-12-24 Size : 4kb User : bac
[Other Embeded program] Matrix-keyboard DL : 0: 该文件实现了 4 * 4 键盘的试验。通过数码管的最后一位来显示当前的按键值-The file realized 4* 4 keyboard experiment. Through the digital pipe of the last to display The current key values
Date : 2025-12-24 Size : 1kb User : yhx244775324
[Other Embeded program] USB_Control_Firmware DL : 0: C++语言编写的针对CY7C68013A芯片的固件程序。包括了对USB Slave FIFO的配置和内部传输管道以及FIFO大小的必要控制。该程序在硬件上通过测试，在没有其他USB设备干扰的应用下，可以确保450Mbps通讯效率。-Firmware control for USB Slave FIFO in CY7C68013A. It define the necessary configuration on transaction segment and pipe as well as FIFO size setting to assure proper 450M bps USB transaction.
Date : 2025-12-24 Size : 1.34mb User : Alex Liu
[Other Embeded program] Ventilation-duct-cleaning-robot DL : 0: 中央空调通风管道清洗机器人软件设计源程序，机器人程序主要有接收数据、前进、后退、左转、右转、停止、摄像头正转、摄像头反转等几种功能。-Central air conditioning and ventilation pipe cleaning robot software design, source code, the robotics program receives data, forward, backward, turn left, turn right, stop, forward camera, camera reversal several functions.
Date : 2025-12-24 Size : 1kb User : 郭佩
[Other Embeded program] c DL : 0: 用单片机写的乒乓球模拟游戏机,c语言编写，用键盘及数码管连接，可调节速度，可报警，可清零-MCU write table tennis simulation game, c language, using the keyboard and digital pipe connection, adjustable speed, the alarm can be cleared
Date : 2025-12-24 Size : 1kb User : 刘海林
[Other Embeded program] Lock DL : 0: 用STC单片机，实现4个数字4位密码锁的功能，并显示在数码管上。具体如下K1,K2,K3,K4,键分别代表数字1，2，3，4，K5为确认键，如果输入用户存放的正确密码，则单片机上的LED实行循环亮灭功能，如输错了3次,LED等则全亮。- Use of STC to achieve four digits 4 lock function, and displayed on a digital pipe. Follows K1, K2, K3, K4, representing key figures 1,2,3,4, K5 is OK button, if you enter the correct password for the user is stored, the LED on the implementation of SCM light off circulation features, such as mistyped 3, LED, etc. are all bright.
Date : 2025-12-24 Size : 40kb User :
[Other Embeded program] msp430-nixietube DL : 0: 用DS18B20测量室温并在数码管上显示。-And displayed on the digital pipe with DS18B20 temperature measurement.
Date : 2025-12-24 Size : 35kb User : 陈文
[Other Embeded program] experiment-exercise-2 DL : 0: 嵌入式cortex-M3开发板开发：以五向键控制led灯柱的闪烁，并将信息显示在4位米字管殇，同时通过uart上传。当有键按下时，蜂鸣器以0.2s周期鸣响，没有键按下时，蜂鸣器不响。-Embedded cortex-M3 development board development: the five key control led to a lamppost flashing, and the information is displayed in 4 m word pipe War, through uart upload. When a key is pressed, the buzzer sounded to 0.2s cycle, no key is pressed, the buzzer does not sound.
Date : 2025-12-24 Size : 257kb User : Gibson