Using L298 as the drive to control two-phase hybrid stepping motor. Buttons from top to bottom respectively, deceleration, acceleration, are being transferred, reverse, stop. Specific parameters have not yet been set. Some of the slow speed, speed up by 2, effectively, and then can not be faster. Speed output is in accordance with the minimum system version of the digital tube wrote. Circuit where not too much trouble drew.

步进电机控制1
.............\001.DSN
.............\001.PWI
.............\001说明.txt
.............\Last Loaded 001.DBK
.............\程序
.............\....\dianji001
.............\....\dianji001.c
.............\....\dianji001.hex
.............\....\dianji001.lnp
.............\....\dianji001.LST
.............\....\dianji001.M51
.............\....\dianji001.OBJ
.............\....\dianji001.Opt
.............\....\dianji001.plg
.............\....\dianji001.Uv2
.............\....\dianji001_Opt.Bak
.............\....\dianji001_Uv2.Bak
.............\....\STARTUP.A51
.............\....\STARTUP.LST
.............\....\STARTUP.OBJ

• We are an exchange download platform that only provides communication channels. The downloaded content comes from the internet. Except for download issues, please Google on your own.
• The downloaded content is provided for members to upload. If it unintentionally infringes on your copyright, please contact us.
• Please use Winrar for decompression tools
• If download fail, Try it againg or Feedback to us.
• If downloaded content did not match the introduction, Feedback to us，Confirm and will be refund.
• Before downloading, you can inquire through the uploaded person information

Nothing．