SCM List Page 385

SCM list

Sort by ：

« 1 2 ... .80 .81 .82 .83 .84 385.86 .87 .88 .89 .90 ... 15240 »

project Downloaded：0: STM32's GPIO configuration, as an engineering template for the car program, does not build the project itself, KEIL5 is available.
Date : 2025-06-08 Size : 5.9mb User : 老李123456
一个水厂综合自动化系统的S7-300程序 Downloaded：0: STEP7 300 program water treatment
Date : 2025-06-08 Size : 619kb User : reedb
FromWH - 副本 Downloaded：0: 89C52 and ADC0808 to achieve the proposed AC sampling
Date : 2025-06-08 Size : 88kb User : 尚恩
Keil C Downloaded：0: Development of electronic cipher lock Change cipher, unlock
Date : 2025-06-08 Size : 64kb User : 枫枫六
自行车里程表的设计 Downloaded：0: There are detailed C programs in the bicycle odometer based on single chip microcomputer
Date : 2025-06-08 Size : 93kb User : 谭志
利用ADC采集通过USART1输出 Downloaded：0: stm32f103 serial send adc data acquisition procedures
Date : 2025-06-08 Size : 1.58mb User : 高手
89c51 Downloaded：0: The design of electronic clock based on STC89C51 includes schematic diagram and test code
Date : 2025-06-08 Size : 195kb User : acchrisrose
stm32f10x_temple-nb-1401011140 Downloaded：0: STM32 development board, through configuring TIM2 channels, 1 channels, 2 and tim3 4 channels, generates six PWM output waves, and is connected with L298N module, controlling and realizing three speed reduction motor's s
Date : 2025-06-08 Size : 673kb User : liuxiaobo
1_Keil_XMC1300-三相六拍 Downloaded：0: The three - phase six - beat control of the permanent magnet motor is mainly set up for CCU4 module.Change the motor speed by changing the proportion of the occupied air.
Date : 2025-06-08 Size : 1.47mb User : dorrit1021
2_Keil_XMC1300-电流采样 Downloaded：0: This program collects the three-phase current value of the motor through the setting of the VADC module in xmc1300.
Date : 2025-06-08 Size : 1.6mb User : dorrit1021
4_Keil_XMC1300-转速计算 Downloaded：0: The calculation of motor speed is realized by setting the POSIF module in xmc1300.
Date : 2025-06-08 Size : 5.93mb User : dorrit1021
3_Keil_XMC1300-PWM斩波 Downloaded：0: The PWM chopper mode is used to drive the permanent magnet motor, which is mainly used to set the CCU8 module in xmc1300.
Date : 2025-06-08 Size : 7.07mb User : dorrit1021

« 1 2 ... .80 .81 .82 .83 .84 385.86 .87 .88 .89 .90 ... 15240 »

Search in result