Location:
Search - tube
Search list
Description: <35 Watt Flowing Gas CO2 Laser Tube Kit>，自制二氧化碳激光发生器。-lt; 35 Watt Flowing Gas CO2 Laser Tube Kitgt; Made of carbon dioxide laser generator.
Platform: |
Size: 833085 |
Author: kata |
Hits:
Description: 一本电子管的老教科书，讲述电子管的原理、制作。-a tube of old textbooks, on the principle of tube production.
Platform: |
Size: 2062826 |
Author: winson |
Hits:
Description: 本代码是关于符点数在数码管上显示的，请注意查收，测试。-code on the website points in the digital displayed on the tube, please note please find test.
Platform: |
Size: 22315 |
Author: 天然 |
Hits:
Description: Digital tube display program design
Digital tube display program design
Digital tube display program design
Digital tube display program design
Digital tube display program design
Platform: |
Size: 4048 |
Author: 244626193@qq.com |
Hits:
Description: <35 Watt Flowing Gas CO2 Laser Tube Kit>，自制二氧化碳激光发生器。-lt; 35 Watt Flowing Gas CO2 Laser Tube Kitgt; Made of carbon dioxide laser generator.
Platform: |
Size: 832512 |
Author: kata |
Hits:
Description: 一本电子管的老教科书，讲述电子管的原理、制作。-a tube of old textbooks, on the principle of tube production.
Platform: |
Size: 2062336 |
Author: winson |
Hits:
Description: 摘 要： 本文件是C8051单片机I2C总线读写测试程序；将跳线器JP6短接，使用外部22.1184MHz晶振.
功能：定义 0 ~ 9 键为数字键， A ~ F 为功能键。按 A 键后，可按0 ~ 9 数字键，
从零地址开始存储该键值，并送LED数码管上显示该键值。按 C 键停止后，按 B 键，
从零地址开始读取数据值，并送LED数码管上显示。读取速度每秒一次。在按 C 键停止后，可按 A 键重新输入。 -Abstract : This document is C8051 MCU I2C Bus literacy test procedures; will be short jumper for JP6 Next, using external 22.1184 MHz oscillator. function : 0 ~ 9 definition of the key figures Key, A-F function keys. A key by, according to figures from 0 to 9 keys, started from zero addresses stored in the pair, and sent digital LED tube revealed that the pair. Key stop by the C, B, according to bond, starting from zero address read data values, and sent LED digital tubes show. Read one per second speed. By the C bond, after the cessation of A bond may re-enter.
Platform: |
Size: 77824 |
Author: |
Hits:
Description: 本代码是关于符点数在数码管上显示的，请注意查收，测试。-code on the website points in the digital displayed on the tube, please note please find test.
Platform: |
Size: 22528 |
Author: 天然 |
Hits:
Description: 我自己编写的74HC595数码管显示程序,一个595驱动两个共阳极数码管-I have written 74HC595 digital tube display program, a total of 595 drive two digital tube anode
Platform: |
Size: 10240 |
Author: 李康保 |
Hits:
Description: LED数码管上显示任意十六进制数字，并且利用中断直接实现扫描-LED digital tube display arbitrary hexadecimal digits, and realize the use of interrupted direct scanning
Platform: |
Size: 25600 |
Author: 张晋 |
Hits:
Description: 单片机是52的，P0口连到四个数码管的七个管脚，其中两个冒号点为最后两个数码管的DOP点，P1.0至P1.3为四个数码管的选通端，低电平有效。程序2较完整，可实现设定时间功能。-Singlechip is 52, P0 port connected to four of the seven-pin digital tube, two of which point to the last two colon tube DOP-point digital, P1.0 to P1.3 for the election of four digital tube pass-side, active-low. 2 a more complete procedure, set the time function can be realized.
Platform: |
Size: 19456 |
Author: 刘琳琅 |
Hits:
Description: 51单片机实现7段数码管显示源代码+Sch电路原理图-51 Singlechip realize 7 digital tube display source code+ Sch circuit schematic
Platform: |
Size: 579584 |
Author: 宇宙的弦 |
Hits:
Description: 使用Cypress的Cy7C68013A芯片进行设计，控制外部LED数码管的显示。程序包括USB固件程序以及主机程序-The use of Cypress s CY7C68013A chip designed to control the external LED digital tube display. This process includes the USB firmware and the host program
Platform: |
Size: 454656 |
Author: feelmen |
Hits:
Description: LPC2124 SPI接口控制LED数码管显示0-F字符,同时控制4个LED显示对应的十六进制程序，包括PROTEUS仿真电路。-LPC2124 SPI interface to control LED digital tube display 0-F characters, simultaneous control of four LED display the corresponding hexadecimal procedures, including PROTEUS simulation circuit.
Platform: |
Size: 254976 |
Author: 龚剑 |
Hits:
Description: 用51单片机实现数字钟
利用数码管、I/O口实现数字钟的计数功能，并显示在数码管上-With 51 single-chip digital clock use of digital control, I/O port to achieve digital clock counting function, and display in the digital tube
Platform: |
Size: 9216 |
Author: winnichan |
Hits:
Description: 74ls164数码管的显示程序，程序完成的功能如下：从0显示到9
-74ls164 digital tube display procedures, procedures for the completion of the function are as follows: from 0 to 9 displayed
Platform: |
Size: 31744 |
Author: liutao |
Hits:
Description: 6位数码管显示程序，通过AT89S/C52,11.0592MHz控制，
显示非常稳定。一个符号位，
5个数据位（3整数，2小数）-6 digital tube display program, through AT89S/C52, 11.0592MHz to control, indicating very stable. A sign bit, 5 data bits (3 integers, 2 decimals)
Platform: |
Size: 1024 |
Author: |
Hits:
Description: 单片机控制时钟芯片DS1302，数码管显示程序-Single-chip microcomputer to control the clock chip DS1302, digital tube display program
Platform: |
Size: 1024 |
Author: Arthur |
Hits:
Description: STC单片机数码管测试程序，P4.0控制595时钟，P4.3控制595锁存，高有效， P4.1为LED 数据输入口-STC Single-chip digital tube test procedure, P4.0 control 595 clock, P4.3 control latch 595, high-effective, P4.1 input data for the LED
Platform: |
Size: 18432 |
Author: xiaohua |
Hits:
Description: 数码管显示的接触式交流稳压器MCU46R47-Digital tube display contact AC voltage stabilizer MCU46R47
Platform: |
Size: 6144 |
Author: 砚波 |
Hits:
« 12
3
4
5
6
7
8
9
10
...
50
»