Description: usb接口的移动硬盘，采用c语言，pidusbd12芯片-usb interface of mobile hard disk drives, using c language, pidusbd12 Chip Platform: |
Size: 286720 |
Author: |
Hits:
Description: TOOLSTICK C8051F931扩展板使用指南:
ToolStick开发板是为工程师使用及学习C8051F单片机提供一个软硬件开发平台，并且支持IDE开发环境。ToolStick开发平台包括底板和扩展板两部分，其中底板通过USB接口连接PC，为MCU与PC通讯提供通道。扩展板上包含目标芯片及一些典型的应用电路(包括GPIO控制LEDs、电位器、一个普通按键、一个电容触摸按键及一些外引的I/O引脚)。
目录：
1.操作说明
2、扩展板组成
3、ToolStick的开发初衷
4、支持软件
5、ToolStick C8051F931扩展板数据日志演示程序
6.使用ToolStick F931扩展板的功能演示
7．附带的演示程序
8. C8051F931 子板原理图 -Expansion board TOOLSTICK C8051F931 Guide: ToolStick development board for the use and learning C8051F Engineer to provide a single-chip hardware and software development platform, and supports the IDE development environment. ToolStick development platform including the floor plate and expansion of two parts, one plate through the USB interface to connect PC, for the MCU to provide channels of communication with the PC. Expansion board that contains the target chip and some typical application circuit (including GPIO control LEDs, potentiometers, an ordinary button, a capacitive touch buttons, and some cited outside the I/O pin). Contents: 1. Operating instructions 2, the expansion of panels 3, ToolStick development of mind 4, support software 5, ToolStick C8051F931 expansion demo board data log 6. ToolStick F931 to expand the use of the function of plate presentation 7. Attached demo program 8. C8051F931 daughter board schematics Platform: |
Size: 281600 |
Author: |
Hits:
Description: This a sample code for STM32F4 DISCOVERY board. It basically gets data from the accelerometer makes some calculations and sends it UART, I use an FTDI chip for uart to usb communication with my PC. With a simple PC program you could collect that data and make a graph or whatever you wish.
I Used CooCox IDE to make that project. It is ready to use if you have that software. Otherwise you can still use the code with a bit of tweaking if for some reason you have different peripheral libraries for that board.-This is a sample code for STM32F4 DISCOVERY board. It basically gets data from the accelerometer makes some calculations and sends it UART, I use an FTDI chip for uart to usb communication with my PC. With a simple PC program you could collect that data and make a graph or whatever you wish.
I Used CooCox IDE to make that project. It is ready to use if you have that software. Otherwise you can still use the code with a bit of tweaking if for some reason you have different peripheral libraries for that board. Platform: |
Size: 325632 |
Author:Rein |
Hits:
Search - program ide to usb