Description: 256色液晶取模软件
适用于S3C44b0X A R M处理器的 L C D 256色
字模提取程序,适用于新手使用.也适合于其他支持
256色 l c d,色位为 R(3) G(2) B(2)的 Lcd
控制器,最大支持640*480的液晶屏.-256 color LCD module from the application software in S3C44b0X R A L M processor 256 C D Color Abstraction procedures applicable to the use of newcomers. Also suitable for other support 256-color l c, d, color-R (3) G (2) B (2) Lcd controller supports 640 x 480 LCD screen. Platform: |
Size: 602577 |
Author:郑家福 |
Hits:
Description: 是msp430的A/D温度转换并直接在LCD上显示其温度植-Controller is the A / D conversion and temperature directly displayed on the LCD temperature implant Platform: |
Size: 12428 |
Author:yangfang |
Hits:
Description: 256色液晶取模软件
适用于S3C44b0X A R M处理器的 L C D 256色
字模提取程序,适用于新手使用.也适合于其他支持
256色 l c d,色位为 R(3) G(2) B(2)的 Lcd
控制器,最大支持640*480的液晶屏.-256 color LCD module from the application software in S3C44b0X R A L M processor 256 C D Color Abstraction procedures applicable to the use of newcomers. Also suitable for other support 256-color l c, d, color-R (3) G (2) B (2) Lcd controller supports 640 x 480 LCD screen. Platform: |
Size: 602112 |
Author:郑家福 |
Hits:
Description: protell99se的一个例子。关于lcd的控制器的设计。
谢谢站长，我一定支持网站发展，请为我开通下载，我十分需要一个源码。-protell99se an example. On the LCD controller design. Thank you, chief, I will certainly support the development site, I opened for downloading, I need a source. Platform: |
Size: 165888 |
Author:wenwen |
Hits:
Description: 是msp430的A/D温度转换并直接在LCD上显示其温度植-Controller is the A/D conversion and temperature directly displayed on the LCD temperature implant Platform: |
Size: 36864 |
Author:yangfang |
Hits:
Description: 车用液晶仪表中s3c2410的can接口程序，can控制器为mcp2515，a/d接口程序，以及主界面显示程序-Vehicle S3C2410 LCD instrumentation in the can interface program, can the controller for mcp2515, a/d interface program, as well as the main interface display program Platform: |
Size: 9216 |
Author:罗杰 |
Hits:
Description: PicoBlaze 处理器放大器和 A/D 转换器控制器
展示了 Linear Technology LTC6912-1 可编程增益放大器和 Linear Technology LTC1407A 模数（A/D）转换器的基本操作。 结果如字符 LCD 屏幕所示。 利用 PicoBlaze 处理器控制器与放大器、A/D 转换器和 LCD 屏幕进行基于 SPI 的通信。-PicoBlaze processor amplifier and A/D converter controller demonstrated the Linear Technology LTC6912-1 programmable gain amplifiers, and Linear Technology LTC1407A modulus (A/D) converter basic operation. The result was as shown in character LCD screen. Use PicoBlaze processor controller and amplifier, A/D converter and SPI-based LCD screen communication. Platform: |
Size: 1906688 |
Author:andy qe |
Hits:
Description: CS8955控制TV软件。用MCU做模拟电视的控制。-CS8955+TV+TNJ7355(tuner).The CS8955 micro-controller is an 8051 CPU core
embedded device targeted for LCD Monitor, LCD TV,
Home Appliance, or Consumer Products application.
The CS8955 is pin-out compatible with MCS-51
family .MCU. It includes an 8051 CPU core, a 64K-byte
internal program Flash-ROM, a 512-byte SRAM, 6
channels of PWM DAC, and 4 channels of 6-bit ADC
(Analog to Digital Converter). It also includes a Boot-
Code-Free ISP (In System Programming), which
allows users to update the programming codes easily.
In addition, there are two IIC Slave B ports supporting
VESA DDC 2B/2Bi/2B+/CI standards for both D-sub
and DVI interfaces in LCD Monitor/TV application. An
external 64K bytes data flash memory can be
accessed by properly setting of Port 0, Port 2 and
Port 3.6/3.7.
Platform: |
Size: 578560 |
Author:martinliao |
Hits:
Description: 3310液晶显示屏C51测试程序
2004/07/31/BD2YA
接脚资料：
Pin Signal Description Port
1:VDD
Power Input. Logic supply voltage range VDD to GND : 2.7 to 3.3 V
2:SCLK
Serial clock. Input for the clock signal: 0.0 to 4.0 Mbits/s.
3:SDIN
Serial data. Input for the data line.
4:D/C
Mode Select. To select either command/address or data input.
5:SCE
Chip enable input. The enable pin allows data to be clocked in. The signal is active LOW.
6:GND
Ground
7:VOUT
Ouptut voltage. Add external 1-10 uF electrolytic capacitor from VOUT to GND
8:RES
External reset. This signal will reset the device and must be applied to properly
initialize the chip. The signal is active LOW.
控制芯片：
PCD8544 */-3310 LCD screen C51 test procedure information 2004/07/31/BD2YA pin: Pin Signal Description Port 1: VDD Power Input. Logic supply voltage range VDD to GND: 2.7 to 3.3 V 2: SCLK Serial clock. Input for the clock signal: 0.0 to 4.0 Mbits/s. 3: SDIN Serial data. Input for the data line. 4: D/C Mode Select. To select either command/address or data input. 5: SCE Chip enable input. The enable pin allows data to be clocked in. The signal is active LOW. 6: GND Ground 7: VOUT Ouptut voltage. Add external 1-10 uF electrolytic capacitor from VOUT to GND 8: RES External reset. This signal will reset the device and must be applied to properly initialize the chip. The signal is active LOW. Controller: PCD8544* / Platform: |
Size: 3072 |
Author:tjh |
Hits:
Description: 本装置采用单相桥式DC-AC逆变电路结构，以TI公司的浮点数字信号控制器TMS320F28335 DSP为控制电路核心，采用规则采样法和DSP片内ePWM模块功能实现SPWM波。最大功率点跟踪（MPPT）采用了恒压跟踪法（CVT法）来实现，并用软件锁相环进行系统的同频、同相控制，控制灵活简单。采用DSP片内12位A/D对各模拟信号进行采集检测，简化了系统设计和成本。本装置具有良好的数字显示功能，采用CPLD自行设计驱动的4.3’’彩色液晶TFT LCD非常直观地完成了输出信号波形、频谱特性的在线实时显示，以及输入电压、电流、功率，输出电压、电流、功率，效率，频率，相位差，失真度参数的正确显示。本装置具有开机自检、输入电压欠压及输出过流保护，在过流、欠压故障排除后能自动恢复。-This device single-phase bridge type DC-AC inverter circuit structure, TI company of floating in digital signal controller TMS320F28335 DSP as the control circuit, the core rules sampling method and DSP piece ePWM module function realization within SPWM wave. The maximum power point tracking (MPPT) used the constant pressure tracking method (CVT method) to realize the software, and phase lock loop to carry on the system the same frequency, phase control, control with flexible simple. By using DSP piece of 12 within the A/D of each simulation signal acquisition detection, simplified system design and cost. This device has a good digital display function, use CPLD to design the driver 4.3 " TFT LCD color LCD very intuitive to finish the output signal waveform and spectrum characteristics of online real-time display, and the input voltage, current, power, the output voltage, current, power, efficiency, frequency, phase difference, the distortion degree of parameters display properly. Thi Platform: |
Size: 5020672 |
Author:徐徐 |
Hits:
Description: 以msp430f149单片机开发板为控制器在12864液晶屏上描画出随A/D输出电压变化的波形-To msp430f149 microcontroller development board for the controller in the LCD screen depicting a 12864 with A/D output voltage waveform Platform: |
Size: 57344 |
Author:lixiaoyan |
Hits:
Description: 一种基于AT89C51单片机的智能温度控制器，采用K型热电偶和专用冷端温度补偿芯片MAX6675构成温度测量电路，由MAX6675输出的数字信号直接送入单片机，一方面通过 LCD 将温度显示出来；另一方面，将该温度与设定的温度值进行比较，根据其偏差的大小，采用改进的数字PID算法对其进行处理得到控制信号，此信号经过D\A转换器DAC0832转换为模拟量输出0～5V。- kind of based on AT89C51 intelligent temperature controller, the K thermocouple and special type of the cold end temperature compensation MAX6675 constitute a temperature measurement circuit chip, MAX6675 output by the digital signal directly into the single chip microcomputer, on the one hand, through the LCD will display temperature On the other hand, will the temperature and setting value, compared the deviation according to the size of the digital PID algorithm of the improved the processing get control signal, the signal through D \ A converter DAC0832 into analog output 0 ~ 5 V.
Platform: |
Size: 12288 |
Author:wangna |
Hits:
Description: μC/GUI 是一种用于嵌入式应用的图形支持软件。它被设计用于为任何使用一个图形LCD
的应用提供一个有效的不依赖于处理器和LCD 控制器的图形
用户接口Ucgui 2-D图形bmp处理-μC/GUI is a graphical support software for embedded applications. It is designed to provide an effective user interface does not depend on the graphics processor and LCD controller Ucgui 2-D graphics bmp deal with any application using a graphical LCD Platform: |
Size: 1024 |
Author:yz |
Hits:
Description: 这是一个基于PT100的水温测量系统。采用STC89C52为主控制器，A/D转换器选用的是TLC2543，使用图形液晶12864显示温度，并可以在液晶上画温度曲线。-It is based on the PT100 temperature measurement system. Based controller using STC89C52, A/D converter of choice is TLC2543, graphical LCD 12864 display temperature, and the temperature profile can be drawn on the LCD. Platform: |
Size: 70656 |
Author:陈岑 |
Hits:
Description: he zigbee protocol instructions,
DM3730 uesd the GPMC port to read
Write your own the DS1302 clock p
I hope a few blog through a few d
DM3730 read and write the FPGA de
APF active filter controller prog
Armboot code analysis it is by th
Based on the spectrum analyzer ms
The ENC28J60 chip-related documen
nios-II remote updata source on-l
TI s LM3S811 drive nokia5110 LCD Platform: |
Size: 8192 |
Author:andy roc |
Hits:
Description: 基于ARM Cortex-M4F(TM4C123)单片机 【功能】微控制器的A/D采集光照强度传感器和电位器的电压，在液晶屏上显示（格式如下，每秒更新一次）
第1行： AD=AIN3(PE0) 【固定不变】
第2行： Light=x.xxx V 【x.xxx 为电压值】
第3行： AD=AIN2(PE1) 【固定不变】
第4行： POT=y.yyy V 【y.yyy 为电压值】(The voltage of the A/D sensor and potentiometer based on the ARM Cortex-M4F (TM4C123) microcontroller [functional] micro controller is displayed on the LCD screen (format as follows, once per second).
The first line: AD=AIN3 (PE0) [fixed]
The second line: Light=x.xxx V [x.xxx as voltage value]
The third line: AD=AIN2 (PE1) [fixed]
The fourth line: POT=y.yyy V [y.yyy as voltage value]) Platform: |
Size: 2195456 |
Author:Der_steppenwolf |
Hits:
Search - lcd controller.d