Location:
Search - USART to UART
Search list
Description: PIC模拟异步串行通讯UART。用TMR0实现定时查询。任何带中断的PIC上都可以实现。可用此法扩展多个串口。-PIC simulation asynchronous serial communications UART. Timing TMR0 with inquiries. Any interruption with the PIC are to be attained. This method can be extended serial number.
Platform: |
Size: 6447 |
Author: 江风 |
Hits:
Description: PIC模拟异步串行通讯UART。用TMR0实现定时查询。任何带中断的PIC上都可以实现。可用此法扩展多个串口。-PIC simulation asynchronous serial communications UART. Timing TMR0 with inquiries. Any interruption with the PIC are to be attained. This method can be extended serial number.
Platform: |
Size: 6144 |
Author: 江风 |
Hits:
Description: 使用DSP软件实现UART功能.一般教科书上提供的UART收发的程序往往是一段采用轮循（Polling）方式完成收发的简单代码。但对于高速的AVR来讲，采用这种方式大大降低了 MUC的效率。在使用AVR时，应根据芯片本身的特点（片内大容量数据存储器RAM，更适合采用高级语言编写系统程序），编写高效可靠的UART收发接口（低层）程序。下面是一个典型的USART的接口程序。-use DSP software UART functions. General textbooks UART transceivers provide the procedure is often used for Round Robin (Polling) transceiver accomplished a simple code. But for the AVR-speaking, the adoption of this approach greatly reduces the efficiency of MUC. The use of AVR, according to the characteristics of the chip itself (large-capacity on-chip data RAM memory, more suitable for the preparation of high-level language system procedures), the preparation of highly efficient and reliable UART interface transceiver (lower) process. Below is a typical USARTs interface procedures.
Platform: |
Size: 5120 |
Author: 张倩 |
Hits:
Description: AVR单片机的Uart口转TWI源程序，包括原理图-AVR MCU Uart I turn TWI source, including schematics
Platform: |
Size: 131072 |
Author: 梁锋 |
Hits:
Description:
Platform: |
Size: 25600 |
Author: 江文杰 |
Hits:
Description: 新型M3核ARM STM32的串口通信例程，可以向计算机发送数据和接受计算机的数据。-New M3 nuclear ARM STM32 serial communication routines, you can send data to the computer and receiving computer data.
Platform: |
Size: 118784 |
Author: 王义 |
Hits:
Description: STM32是以Cortex-M3为核的处理器，该例程介绍STM32下如何对串口进行操作。串口是最基本的调试输入输出接口。-Cortex-M3 based STM32-core processor for the routine introduction STM32 how to operate on the serial port. Serial debugging is the most basic input-output interface.
Platform: |
Size: 168960 |
Author: 熊刚 |
Hits:
Description: ATMEGA128 UART 的IAR应用-ATMEGA128 UART application of IAR
Platform: |
Size: 1024 |
Author: |
Hits:
Description: 本程序实现USART通信，基于PIC16F877芯片开发的。里面一个是发送程序，一个是接受程序。-USART communication implementation of this procedure, based on the PIC16F877 chip development. Inside a procedure are sent, one is to accept the procedure.
Platform: |
Size: 1024 |
Author: 林东海 |
Hits:
Description: ATMEL AT91SAM926x 测试程序。在ADS环境下测试AT91SAM926x串口。-ATMEL AT91SAM926x test procedure. In the ADS environment to test serial AT91SAM926x.
Platform: |
Size: 68608 |
Author: zwj |
Hits:
Description: USART以查询方式收发数据，接收发自电脑的数据，将其显示在LED上，并将接到到的数据减1后返回电脑-USART to send and receive data to query, receive from the bottom of the computer data that could be displayed in the LED, and will receive the data returned by a computer
Platform: |
Size: 84992 |
Author: 张栋 |
Hits:
Description: atmega128的串口通信源程序。编程风格很好，容易读懂。-atmega128 serial communication source. Good programming style, easy to read.
Platform: |
Size: 50176 |
Author: wty |
Hits:
Description: 一般教科书上提供的UART收发的程序往往是一段采用轮循（Polling）方式完成收发的简单代码。但对于高速的AVR来讲，采用这种方式大大降低了MUC的效率。在使用AVR时，应根据芯片本身的特点（片内大容量数据器RAM，更适合采用高级语言编写系统程序），编写高效可靠的UART收发接口（低层）程序。下面是一个典型的USART的接口程序。-General textbook on the procedures provided by the UART transceivers often use a round robin (Polling) a simple manner to send and receive code. But for high-speed AVR speaking, this approach greatly reduces the efficiency of MUC. When using the AVR should be based on the characteristics of the chip itself (on-chip high-capacity data device RAM, more suitable for high-level language for writing system programs), the preparation of highly efficient and reliable UART transceiver interface (lower) program. The following is a typical USART interface program.
Platform: |
Size: 2048 |
Author: 男人 |
Hits:
Description: Also the USART automatically senses the start of transmission of RX line and then inputs the whole byte and when it has the byte it informs you(CPU) to read that data from one of its registers.
The USART of AVR is very versatile and can be setup for various different mode as required by your application. In this tutorial I will show you how to configure the USART in a most common configuration and simply send and receive data. Later on I will give you my library of USART that can further ease you work. It will be little complicated (but more useful) as it will have a FIFO buffer and will use interrupt to buffer incoming data so that you are free to anything in your main() code and read the data only when you need. All data is stored into a nice FIFO(first in first out queue) in the RAM by the ISR.
Platform: |
Size: 1024 |
Author: sstefan |
Hits:
Description: The concept of this thesis not a new one. Accelerometers have been used before in various forms to log accelerations and reaction forces in numerous sports.ADC+UART files is ataached here. The motivations for this can either be in the interests of injury prevention, technique improvement, or both. However, often the hardware is obtrusive and hinders the athlete’s technique, sometimes causing the athlete to alter his or her movement and mask the original problem. The aim of this project is to create an unobtrusive datalogging device to record acceleration profiles with the goal of detecting injury causing abnormalities in technique.-The concept of this thesis is not a new one. Accelerometers have been used before in various forms to log accelerations and reaction forces in numerous sports.ADC+UART files is ataached here. The motivations for this can either be in the interests of injury prevention, technique improvement, or both. However, often the hardware is obtrusive and hinders the athlete’s technique, sometimes causing the athlete to alter his or her movement and mask the original problem. The aim of this project is to create an unobtrusive datalogging device to record acceleration profiles with the goal of detecting injury causing abnormalities in technique.
Platform: |
Size: 8192 |
Author: raja |
Hits:
Description: 学习使用contex-m3的stm32f103c6的程序库，ADC-UART驱动程序。-Learn to use contex-m3 of stm32f103c6 the library, ADC-UART driver.
Platform: |
Size: 1415168 |
Author: 杨振军 |
Hits:
Description: //DMAVR-128的USART串口发送与接收数据示例程序，采用串口1，发送和接收都是中断的方式
//先发送200个FF，然后单片机处于接收状态，接收数据显示在数码管上，电脑发送的数据格式如09，16进制形式-//DMAVR-128 USART serial port to send and receive data sample program using the serial port to send and receive are interrupted// 200 sends the FF, then the microcontroller in the receiver, the receive data displayed in the digital tube, computer send the data format, such as 09,16 hexadecimal form
Platform: |
Size: 2048 |
Author: 周舟 |
Hits:
Description: 该程序为UART程序。
通信协议为：
1.假如接收到A或a，则向电脑发送0到9
2.假如收到8，则停止发送数据
3.否则轰鸣器报警。
-The program for the UART program. The communication protocol is: 1. Received A or a computer to send 0-9 2. Received eight, stop sending data. Otherwise roar Alarm.
Platform: |
Size: 1024 |
Author: shenzhe |
Hits:
Description: 定向printf函数到串口，使用轮询方式接收数据，使用USART1，USB TO UART接口。-Printf function directed to the serial port using polling to receive data using USART1, USB TO UART interface.
Platform: |
Size: 2211840 |
Author: myname |
Hits:
Description: 1 支持串口收发
2 支持串口数据解析
3 支持自定义发送数据(1 can read/write usart data
2 can analysis data from uart
3 can custom data to send)
Platform: |
Size: 2845696 |
Author: zzhcore122
|
Hits: